How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Pete Your Own Question
Pete
Pete, Cadillac Technician
Category: Cadillac
Satisfied Customers: 25350
Experience:  17 years Cadillac experience as a technician.
14928985
Type Your Cadillac Question Here...
Pete is online now
A new question is answered every 9 seconds

1995 seville. Regulator is fine. Replacing window. how do

Customer Question

1995 seville. Regulator is fine. Replacing window. how do you get the regulator arms in the track to raise and lower the window? Drivers window.
Submitted: 1 year ago.
Category: Cadillac
Expert:  Pete replied 1 year ago.
My name is ***** ***** I am a professional here at Just Answer. I noticed that your question was not getting a response and thought I would see if you still need help with this.I apologize for the delay and I hope I can still assist you with this here.
Below is the installation procedure with some links to check as this is a regulator/module assembly to connect to the window.If you need more info let me know.
INSTALL OR CONNECT
1. Position lock module to door, hang module on studs and hand start nuts and bolts.
2. Three screws retaining lock to door.
3. Tighten nuts and bolts.
https://www.dropbox.com/s/ebsfxa7agnjlcpq/reg-08-17.gif?dl=0
https://www.dropbox.com/s/9pqc33np7v7cnym/regu-08-17.gif?dl=0
TIGHTEN
^ Tighten in proper sequence.
^ Nuts to 6 N.m (53 lb in).
^ Bolts to 6.7 N.m (59 lb in).
4. Wiring harness.
5. Rivets retaining window to sash.
6. Outside handle and lock rods to lock.
7. Water deflector.
8. Trim panel.
Thanks Pete