How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Dave Nova Your Own Question
Dave Nova
Dave Nova, Buick Technician
Category: Buick
Satisfied Customers: 19450
Experience:  ASE Master Certification. GM World Class Certification
Type Your Buick Question Here...
Dave Nova is online now
A new question is answered every 9 seconds

The drivers side sun visor removed and replaced without damage

Resolved Question:

How is the driver's side sun visor removed and replaced without damage to anything.
2000 Regal
Submitted: 5 years ago.
Category: Buick
Expert:  Dave Nova replied 5 years ago.

Hello and thank you for using justanswer.


  1. Rotate the sunshade so that the bottom edge is pointing straight down.
  2. Remove the sunshade from the anchor.



  1. Move the sunshade rearward, about 50 mm (2 inches) until the ridge on the sunshade stem (2) is flush to the slot in the flange (1).
  2. Pull down on the free end of the sunshade until a rectangular slot (3) appears between the flange and the retainer bezel. Maintain this pressure for the next two steps.



Important: The flat-bladed tool used to remove the sunshade must completely fill the slot on the sunshade flange. If there is any free play, the plastic flange will be distorted and the sunshade will not be released.

  1. Insert a flat-bladed tool in the flange slot. Hold this tool in a vertical position and maintain an upward pressure on the tool equal to the downward pressure on the sunshade.
  2. Quickly rotate the sunshade rearward approximately 100 mm (4 in). At this position you will feel a first disengagement.
  3. Maintain the upward pressure on the flat-bladed tool and now press upward on the free end of the sunshade. Then continue to rotate the sunshade towards the side door glass.
  4. Remove the flat-bladed tool and pull down on the front of the sunshade arm to separate it from the bezel.



Disconnect electrical connector (3)

Dave Nova and 4 other Buick Specialists are ready to help you

Related Buick Questions