How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask GM Tech (Cam) Your Own Question
GM Tech (Cam)
GM Tech (Cam), Buick Technician
Category: Buick
Satisfied Customers: 29442
Experience:  GM Grand Master Technician 2007. 11 years experience.
10949255
Type Your Buick Question Here...
GM Tech (Cam) is online now
A new question is answered every 9 seconds

Repair door handle driver side 2006 buick rainier

Resolved Question:

repair door handle driver side 2006 buick rainier
Submitted: 7 years ago.
Category: Buick
Expert:  GM Tech (Cam) replied 7 years ago.
Welcome. Inner or outter door handle?
Customer: replied 7 years ago.
outer
Expert:  GM Tech (Cam) replied 7 years ago.

OK, below are instructions.

 

Object Number: 690976  Size: SH

  • Lift up on the front edge of the switch panel in order to release the front retaining clip.
  • Lift up on the rear edge of the switch panel in order to release the 2 rear retaining clips.
  • If equipped, disconnect the electrical connectors from the driver door module (1).
  • If replacing only the driver door module, remove the module from the door trim panel.
  • Disconnect the remaining electrical connectors from the switch panel.
  • If replacing only the switch panel, retain the driver door module for transfer.
  • Remove the switch panel assembly from the vehicle
  •  

    Object Number: 683551  Size: SH

  • Remove the 2 trim panel retaining bolts (1 and 2).
  • Use a trim tool in order to release the 9 trim panel fasteners from the door.
  • Remove the trim panel from the door.
  • Remove the inside door handle bezel.
  • Object Number: 730435  Size: SH

  • Remove the rear half of the water deflector from the door.
  • Release the upper lock rod retainer (1) from the rod.
  • Remove the lock rod from the handle assembly.
  • Release the lock cylinder rod retainer (2) from the lock rod, if equipped.
  • Remove the lock cylinder rod from the handle assembly, if equipped.
  • Remove the 2 door handle retaining nuts.
  • Remove the handle assembly from the door.
  • Remove the lock cylinder from the handle, if equipped.
  • GM Tech (Cam) and 7 other Buick Specialists are ready to help you

    Related Buick Questions