How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Greg A Your Own Question
Greg A
Greg A, Master Troubleshooter
Category: Buick
Satisfied Customers: 8349
Experience:  Working with Electronics & Cars for 25+ Years
5229702
Type Your Buick Question Here...
Greg A is online now
A new question is answered every 9 seconds

How do I remove the glove box in a 2004 Buick Lesabre Limited

Resolved Question:

How do I remove the glove box in a 2004 Buick Lesabre Limited
Submitted: 7 years ago.
Category: Buick
Expert:  Greg A replied 7 years ago.

Hello & Welcome,

 

Here is what the manual says:

 

Storage Compartment Replacement - Instrument Panel (I/P)

Removal Procedure


    graphic

  1. Open the instrument panel (IP) compartment door.
  2. Remove the fasteners (2) that secure the storage compartment (1) to the IP.
  3. Disconnect the electrical connector (4) for the storage compartment lamp (3).
  4. Remove the IP storage compartment from the IP by pulling toward the rear of the vehicle.

Installation Procedure


    graphic

  1. Connect the electrical connector (4) for the storage compartment lamp (3).
  2. Install the IP storage compartment (1) to the IP by sliding in toward the front of the vehicle.

    Notice

    Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

     

  3. Install the IP storage compartment fasteners (2) to the IP. Tighten

    Tighten the fasteners to 2 N·m (18 lb in).

  4. Close the IP compartment door.

I hope this helps. Please let me know if you need more information.

 

Take Care, Greg A.

Greg A and other Buick Specialists are ready to help you