How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Dominick Your Own Question
Dominick
Dominick, Marine Mechanic
Category: Boat
Satisfied Customers: 1009
Experience:  25 Years Experience as Mechanic, 20 Yrs Boat Yard Owner/Mechanic, Factory Certified
14379177
Type Your Boat Question Here...
Dominick is online now
A new question is answered every 9 seconds

Again experts!I just installed my first Evinrude E-TEC

Customer Question

Hi again experts! I just installed my first Evinrude E-TEC 130 hp. Everything seems to be OK, but the instruments. I don't get any engine data to the ICON Pro instruments. When I start the engine, it shows 0.0 rpm, 0.0 volt, 0.0 water pressure etc. All the wiring seems to be correct, but maybe I have forgot something? I'm not sure the NMEA network is active. Can you exactly describe where in the engine the NMEA cable should be connected? I have connected this way: http://www.ladda-upp.se/bilder/zikjcwrmqfubph/ http://www.ladda-upp.se/bilder/htiuvyywauxxaq/ http://www.ladda-upp.se/bilder/xsryulqsmxkdj/ There is also at least two connections at the engine that is not in use. What are they for? Does the NMEA system or the ICON instruments need to be calibrated maybe? I'm looking forward to any advice. The engine itself is running just fine, without any faults according to the EvDiagnostics monitor.

Edit: It seems like I have solved the problem. It was a terminator missing at the NMEA T-connector. Battery voltage and oil level is now detected. I will start engine tomorrow. Hopefully the RPM will also work!

Submitted: 1 year ago.
Category: Boat

Related Boat Questions