How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask indy-tech Your Own Question
indy-tech
indy-tech, Australia Car Mechanic
Category: Australia Car
Satisfied Customers: 7027
Experience:  All import and domestic car repairs and diagnostics
29331485
Type Your Australia Car Question Here...
indy-tech is online now
A new question is answered every 9 seconds

How do I program a remote door lock after fitting a new

Customer Question

how do I program a remote door lock after fitting a new battery?
JA: Have you tested the battery with a voltmeter? And can you see if it's leaking or not?
Customer: Old remote battery was flat,,,new one has been fitted
JA: What is the model/year of your Mitsubishi?
Customer: 2007 ML Triton Diesel
JA: Are you fixing your vehicle yourself? What have you tried so far?
Customer: I have replaced the battery in the remote door lock key fob
JA: Anything else you want the mechanic to know before I connect you?
Customer: no
Submitted: 14 days ago.
Category: Australia Car
Expert:  indy-tech replied 14 days ago.

Hi, I'm Greg (Indy-Tech).
Welcome to JustAnswer. I'm reviewing your question now, and will post back with your reply ASAP.
Rgds Greg.

Expert:  indy-tech replied 14 days ago.

NOTE:

The vehicle may be fitted with an aftermarket alarm/central locking system.

System operation Pressing remote control lock button once activates central locking.

Indicators and interior lamp will flash twice.

Pressing remote control unlock button once deactivates central locking.

Indicators will flash four times.

If vehicle unlocked and doors or tailgate not opened within 30 seconds, locks are reactivated.

Programming When Remote control added or replaced.

System malfunction.

How Earth terminal 1 of data link connector (DLC) Fig. 1 Attached .

Close all doors.

Turn ignition switch to ACC position and then back to OFF position 3 times within 10 seconds.

Doors should lock then unlock.

Press remote control lock or unlock button once.

Press remote control lock or unlock button twice within 10 seconds.

Doors should lock then unlock.

Repeat above procedure within 1 minute to program remaining remote controls.

Remote controls can also be programmed using diagnostic equipment.

Fig. 1 attached

NOTE:

A maximum of 2 remote controls can be programmed.

If you need further assistance with this issue then please get back to me with the reply box below .
This is not a one answer and done i/we will stay with you until the problem is sorted out .
Before rating poor or bad please get back to me as i'm here to help you and if i can't i will opt out so another expert can , we want you to be happy and have your problem sorted out and be a happy motorist .
After rating there is no further cost for any other question relating to this problem
Kind regards Greg..