How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis Your Own Question
Curtis
Curtis, Australia Car Mechanic
Category: Australia Car
Satisfied Customers: 1606
Experience:  Qualified Automotive Mechanic, LPG & Airconditioning Diagnostic Technician.
29271542
Type Your Australia Car Question Here...
Curtis is online now
A new question is answered every 9 seconds

I am having code p2291 on 2011 ford ranger, p2290 injector

Customer Question

i am having code p2291 on 2011 ford ranger
JA: Just to clarify, what's the exact code? And have you tried to reset it?
Customer: p2290 injector control pressure too low
JA: Are you fixing your Ranger yourself? What have you tried so far?
Customer: yes changed fuel filter
JA: Anything else you want the mechanic to know before I connect you?
Customer: clean fuel tank
Submitted: 1 month ago.
Category: Australia Car
Expert:  david craig replied 1 month ago.

Hi Im David, thanks for visiting the site what engine do you have in your ranger?

Customer: replied 1 month ago.
2.2 duratorq tdci
Customer: replied 1 month ago.
6 speed auto
Expert:  david craig replied 1 month ago.

Make sure the filter is full of fuel first. Then the battery is fully charged.

Loosen off the nuts on top of the injectors and crank in short bursts until fuel starts to come out. Tighten the nuts and repeat the process one injector at a time if it hasn't started after the first procedure. The crucial thing is to not crank for long periods as this can damage the pump due to it being lubricated by the diesel and if it is airlocked it can be damaged. It is important that you either have a filly charged battery or at least have another car to boost yours off.

Customer: replied 1 month ago.
David this car will start and idle fine the problem is revs up to 2000 will go to limp mode
Expert:  david craig replied 1 month ago.

ok, what code do you have? 2290 or 2291?

Customer: replied 1 month ago.
2290
Expert:  david craig replied 1 month ago.

well it said 2291 up top. just checking

Expert:  david craig replied 1 month ago.

i will opt opt i dont have the information for your vehicle here in the states to be able to help

Related Australia Car Questions