How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask indy-tech Your Own Question
indy-tech
indy-tech, Australia Car Mechanic
Category: Australia Car
Satisfied Customers: 6796
Experience:  All import and domestic car repairs and diagnostics
29331485
Type Your Australia Car Question Here...
indy-tech is online now
A new question is answered every 9 seconds

Hard to start keep coming up with crank sensor fault but i

Customer Question

hard to start keep coming up with crank sensor fault but i just put a new one in
JA: Does the vehicle stall at low speeds? Does it sputter?
Customer: no
JA: What is the model/year of your Nissan?
Customer: 2005
JA: Are you fixing your vehicle yourself? What have you tried so far?
Customer: its a customers car just put a new crank sensor in it but keeps throwing p1335 crank sensor code
JA: Anything else you want the mechanic to know before I connect you?
Customer: no
Submitted: 2 months ago.
Category: Australia Car
Expert:  indy-tech replied 2 months ago.

Hi, I'm Greg (Indy-Tech).
Welcome to JustAnswer. I'm reviewing your question now, and will post back with your reply ASAP.
Rgds Greg.

Customer: replied 2 months ago.
thanks
mick
Expert:  indy-tech replied 2 months ago.

Hi Mick .

Is this the Only code you have and did you use a OEM sensor or a Aftermarket sensor .

Greg

Customer: replied 2 months ago.
aftermarket
Customer: replied 2 months ago.
its the only code p1335 crankshaft position sensor reference fault
Expert:  indy-tech replied 2 months ago.

Hi Mick .

Just has the same issue in my shop only yesterday ,problem was also a aftermarket sensor .

Nissan management system work with very small parameters and if the aftermarket is not within these it will flag the same code .

Which model and engine do you have .

Possible causes

Faulty Crankshaft Position Sensor

Crankshaft Position (CKP) Sensor harness is open or shorted

Crankshaft Position (CKP) Sensor circuit poor electrical connection

Signal plate may be damage

Starter motor may be faulty

Starting system circuit

Dead or weak battery

Check the wiring harness from the sensor to the ECM for any damage .

Rgds Greg