How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08
sprinkles08, ASE Certified Technician
Category: Australia Car
Satisfied Customers: 21606
Experience:  ASE Master and Advanced level certified. Factory trained with 15 years dealership experience
9825021
Type Your Australia Car Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

Change crank angle sensor Mitsubishi magna not firing, not

Customer Question

change crank angle sensor Mitsubishi magna not firing
JA: Does the vehicle stall at low speeds? Does it sputter?
Customer: not starting at all
JA: What is the model/year of your Mitsubishi?
Customer: 2004
JA: Are you hoping to fix this yourself? What have you tried so far?
Customer: I put a new crank angle sensor in it
JA: Anything else you think the mechanic should know?
Customer: not firing
Submitted: 4 months ago.
Category: Australia Car
Expert:  david craig replied 4 months ago.

Hi Im David. the reason for changing the crank sensor?

Customer: replied 4 months ago.
sputter at low seed
Expert:  david craig replied 4 months ago.

After reading the previous info, it says wont start at all. so since you've replaced the crank sensor, its starting now? but sputtering?

Expert:  david craig replied 4 months ago.

hello???????????

Expert:  sprinkles08 replied 4 months ago.

Hello and welcome to JustAnswer!

There are quite a few things that could be causing a lack of spark. If the no start condition started as a result of replacing the crank sensor though there is a good chance that the problem is directly related to that repair. It's possible that the sensor isn't fully installed, there may be a wiring or connection issue, and you may have gotten a bad replacement sensor.

Where did the sensor come from?
Does a scan tool communicate with the engine controller?

Related Australia Car Questions