How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis Your Own Question
Curtis, Australia Car Mechanic
Category: Australia Car
Satisfied Customers: 1634
Experience:  Qualified Automotive Mechanic, LPG & Airconditioning Diagnostic Technician.
Type Your Australia Car Question Here...
Curtis is online now
A new question is answered every 9 seconds

Toyota: timing marks..diesel engine..camshaft..a line on the pulley I

Customer Question

need to locate timing marks on toyota 2c diesel engine. I am unable to locate or distinguish camshaft timing marks. there's a line on the pulley I can see but cant locate aligning mark on engine block.
a picture or a diagram would be helpful.
Submitted: 5 years ago.
Category: Australia Car
Expert:  Curtis replied 5 years ago.
Year model and make please?
Customer: replied 5 years ago.
Its a toyota tarago but has a replacement import engine Totota 2C diesel engine. they were in liteace 1992-1995
Expert:  Curtis replied 5 years ago.
I will upload this diagram for you.
Curtis and other Australia Car Specialists are ready to help you
Customer: replied 5 years ago.
I have accepted in advance I think, so hope this will give me the rifgt solution. Just how am I going to receive the diagram?
Customer: replied 5 years ago.
my email is;[email protected] if you want to send the diagram there
Customer: replied 5 years ago.
krys946 at hotmail
Expert:  Curtis replied 5 years ago.
Uploading now will post it as an answer.
Expert:  Curtis replied 5 years ago.
Customer: replied 5 years ago.

The Pully on the crankshaft has a groove which I can align with prodruding mark (like a needle) on the motor body - So I think I got this right and fuel pump pully has a dot which aligns with a line on the body (about 4 o'clock) so I think I got that right.

So, just to verify marking line on camshaft pully wheel should be 90 degrees east (right) in line with camshaft engine cover gascet.
Not sure what the red mark at 12 o'clock is. is it just marking the top? - The top red mark (at 12 o'clock) lines up with two dots on the camshaft pully wheel sprockets and the line on the edge is at 90 degrees to the right (as shown on your diagram) of the 2 dots.
Expert:  Curtis replied 5 years ago.
Everything is correct, the line at the top of the camshaft is if the timing belt has a line marking on it.
Customer: replied 5 years ago.
Bit late to have a go now but will try tmw. Thank you for your help.
Cheers Krystof
Expert:  Curtis replied 5 years ago.
No worries, anytime

Related Australia Car Questions