How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Don 'Mo Lurch' Your Own Que...
Don 'Mo Lurch'
Don 'Mo Lurch', Mechanic
Category: Audi
Satisfied Customers: 20522
Experience:  Heavy Line Mech-, Mobile Electronics. Sales, Installation & Repair for 30 years. R/S, etc.
1609972
Type Your Audi Question Here...
Don 'Mo Lurch' is online now
A new question is answered every 9 seconds

I need to know where the wires left front ABS sensor go to

Customer Question

I need to know where the wires for the left front ABS sensor go to from the sensor, I have replaced the sensor but it still shows no reading from the sensor, I'm assuming the fault is with the unit that reads the information from the sensor can you help?
Submitted: 1 year ago.
Category: Audi
Expert:  Kevin replied 1 year ago.

Hi I'm Kevin can I have your vehicle reg number and il see what info I have

Customer: replied 1 year ago.
Sy52vxs
Customer: replied 1 year ago.
R u still there?
Expert:  Kevin replied 1 year ago.

I have limited info the wires will go back to abs module but I don't have PIN numbers for plug so il opt out another expert may have this info for you

Expert:  Don 'Mo Lurch' replied 1 year ago.

.

sorry for the delay............
.
Greetings...... “Hi, I’m Don (aka MOLurch) and I look forward to helping you!”
.
All Sensor wires go into the loom & feed into the Passenger side to the ABS Control Module

The ABS Control Module is located under floor covering in front passenger's footwell

To Replace control module;

•Remove bottom A-pillar trim.
•Remove floor covering.
•Loosen screws securing ABS Control Module.
•Unplug connector from ABS Control Module.
•Install new control module in reverse sequence.
.Tightening torque of screws 9 Nm.

.

You can test for short or reading from the individual Sensors with Ohm Meter & turning wheel, but use of Scan Tool is needed to Test & Program ABS.

click Attachment below

.
IF you need more information, please ask "prior" to Rating.
.
Please do the right thing and leave a rating, using the rating system, so I may be credited for this Q&A.
.
NOTE: Do NOT Rate on how much TIME you waited, because I am not on 24 / 7 and I answer as soon as I see the question.
The question will still remain open for follow up questions if needed.
.
If for any reason, you can't rate my answer OKAY, GOOD, or EXCELLENT today.
Please reply and let me know why, so I can help more/better.
.
Rating is very Important to our Service
.
.

Expert:  Don 'Mo Lurch' replied 1 year ago.

.

Related Audi Questions