How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask AppTech8579 Your Own Question
AppTech8579
AppTech8579, Home Appliance Technician
Category: Appliance
Satisfied Customers: 1607
Experience:  worked on appliances for around 10 years
76126576
Type Your Appliance Question Here...
AppTech8579 is online now
A new question is answered every 9 seconds

Whirlpool front load E01 and F09 codes. Machine pumps out

Customer Question

Whirlpool front load E01 and F09 codes . Machine pumps out ok, lint trap is clean.
JA: Can you guesstimate how old your Whirlpool is? And just to clarify, what's the exact model?
Customer: About 3 or 4 years old
JA: Do you plan on doing the work yourself?
Customer: If I can
JA: Anything else we should know to help you best?
Customer: I think the main board, but I can't rule out the pressure switch
Submitted: 5 months ago.
Category: Appliance
Expert:  AppTech8579 replied 5 months ago.

Please post model number.

Customer: replied 5 months ago.
WFW94HEXW2
Expert:  AppTech8579 replied 5 months ago.

F9E1:
LONG DRAIN: If the drain time exceeds 8 minutes without reaching reset level in pressure sensor, the valves are turned off and the drain pump will stop running. NOTE: Suds can cause delays in draining. Washer drains for 4 minutes, pauses 5 minutes, then tries again for 4 additional minutes of draining. F9E1 will display if washer does not drain. (Normal drain takes less than 2 minutes)

Possible Causes:
Verify that the drain hose is not blocked or kinked.
Make sure drain hose is not sealed into drain pipe.
Make sure the drain hose height does not exceed 96" (2.4 m).
Check/clean drain pump filter of foreign objects.
Check connections from tub to air trap, air trap to pressure hose, and pressure hose to pressure sensor.

Using the Star Rating Chart at the top of your page and rating me at least a 5 star is how I receive payment for helping you. Please if you do not understand my answer, don't hesitate to ask for more help. BONUSES appreciated.

Customer: replied 5 months ago.
The washer is draining completely, but the pump runs long past the tub is empty, until it displays an error code.. I doesn't over fill as far as I can see. So I think the pressure switch is working..
Expert:  AppTech8579 replied 5 months ago.

Then either the drain pump or control board is faulty and needs replaced.

Customer: replied 5 months ago.
I've cleaned the lint trap, there was hardly anything in it. I get the error when I run empty with just water.
Expert:  AppTech8579 replied 5 months ago.

Id say this is the control board faulty.

Expert:  AppTech8579 replied 5 months ago.

Please dont forget to use the star rating link to rate me a 5 before you leave, Thanks!