How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Kelly Your Own Question
Kelly
Kelly, Appliance Technician
Category: Appliance
Satisfied Customers: 21207
Experience:  Highly accurate diagnostician with over 30 years experience!
11418111
Type Your Appliance Question Here...
Kelly is online now
A new question is answered every 9 seconds

U-line 75R will not run at all. I can' hear

Customer Question

U-line 75R will not run at all. I can' hear anything...........the light is on?
JA: I'll do all I can to help. How long have you been dealing with this?
Customer: 3 days
JA: Do you plan on doing the work yourself?
Customer: Yes. I'm guessing it might be the start relay or themostat??
JA: Anything else we should know to help you best?
Customer: I replace the control part # 2766-s 4 years ago.
Submitted: 7 months ago.
Category: Appliance
Expert:  Kelly replied 7 months ago.

Thanks for counting on us to help with your appliance problem. My name is ***** ***** I look forward to helping you!

Expert:  Kelly replied 7 months ago.

The issue is likely with the main control again. If you do not hear the compressor coming on (or trying), that would be the case. Is the compressor getting warm at all?

Customer: replied 6 months ago.
I have replaced the cold controls 3 times in the last 15 years. Are you sure it's not the starter relay or do you overload? Why would the cold control go out so many times.
Customer: replied 6 months ago.
Are you sure it's the cold control and not the start relay or overload?
Expert:  Kelly replied 6 months ago.

If the start relay was bad, the compressor would attempt to start. You stated it is not making any noise at all. You can measure voltage at the compressor to verify control failure. No voltage would indicate faulty control.

Related Appliance Questions