How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Jamie_2013 Your Own Question
Jamie_2013
Jamie_2013, Handyman
Category: Appliance
Satisfied Customers: 1527
Experience:  worked on appliances for around 6 years
76126576
Type Your Appliance Question Here...
Jamie_2013 is online now
A new question is answered every 9 seconds

How do I dry the sensor in a DD602 Fisher and Parkyel

Customer Question

How do I dry the sensor in a DD602 Fisher and Parkyel dishwsher
JA: Thanks. Can you give me any more details about your issue?
Customer: had the f1 fault on both drawers. Other models show you need to dry the circuit board after removing the drawer. I do not see a circuit board in this model, just a plastic sealed receptical
JA: OK got it. Last thing — Appliance Technicians generally expect a deposit of about $18 to help with your type of question (you only pay if satisfied). Now I'm going to take you to a page to place a secure deposit with JustAnswer. Don't worry, this chat is saved. After that, we will finish helping you.
Submitted: 11 months ago.
Category: Appliance
Expert:  Jamie_2013 replied 11 months ago.

Can you pull the dishwasher out in the middle of the floor?

Customer: replied 11 months ago.
No. I have the drawer off and on its side.
Expert:  Jamie_2013 replied 11 months ago.

Underneath the dishwasher is a base pan. Was there water in there?

Customer: replied 11 months ago.
Expert:  Jamie_2013 replied 11 months ago.

Make sure to dry it all up and try the unit again, let me know. F1 tells you water is in the base (flood mode)

Expert:  Jamie_2013 replied 11 months ago.

Please be sure to rate me before you go and post back here if you need more help at no additional charge, thanks!