Need Appliance Repair Help? Ask a Technician for Answers ASAP
There is not a quick fix unfortunately but if you're handy you can fix the issue. Unfortunately these washers are not easy at all to access and fix a drain problem. There is a drain catch inside the washer that you will want to access and clean if you're getting this drain error. To access the drain catch, it's very difficult. The top panel, the control panel, and the entire front panel all need to be removed so that you can access the pump below the tub. It's really a bad design and it was never this difficult in the past, but now there is quite a bit of work involved to clear the drain so unless you're really handy, this is not something you'll want to tackle yourself. To access the drain pump, you need to pull the washer forward and unplug it. Pull the dispenser drawer completely off the washer. Next, remove the 2 bolts coming in from the back of the top panel. The top panel will pull straight back, up, and off. Remove the screws coming in through the dispenser opening and the screws coming from the inside of the washer going into the control panel. The control panel will then pull up and out of the way. At this point, you just have a few screws going across the top of the front panel to remove. Tip the wash back a bit and there are 2 screws in the bottom right and left corner you need to remove. Open the door and you need to disconnect the rubber door gasket. There is a wire ring around the front lip of the rubber door gasket. Use a flat head screwdriver and pry the wire ring off the gasket. Now you can remove the front panel to access the drain pump located under the drum attached to the drain catch.
We are on the honor system here. Please remember to rate my service by selecting a star at the top of the screen before you leave today. If you need anything else, just let me know. You can continue asking follow-up questions at no additional charge after rating my service if you still need assistance.