How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Kelly Your Own Question
Kelly
Kelly, Appliance Technician
Category: Appliance
Satisfied Customers: 19055
Experience:  Highly accurate diagnostician with over 30 years experience!
11418111
Type Your Appliance Question Here...
Kelly is online now
A new question is answered every 9 seconds

I just replace the control board and get the same result,,no

Customer Question

I just replace the control board and get the same result,,no start
Submitted: 1 year ago.
Category: Appliance
Expert:  Appliance Medic replied 1 year ago.
Welcome and thank you for your question. I will be the professional that will be assisting you.
Hi, what is the part number of the board you replaced?
Thank you
Customer: replied 1 year ago.
22002989
Expert:  Appliance Medic replied 1 year ago.
Does the old board have a burnt resistor on it?
Customer: replied 1 year ago.
No, it didn't
Expert:  Appliance Medic replied 1 year ago.
Do the lights on the panel come on?
Customer: replied 1 year ago.
No!
Customer: replied 1 year ago.
I did what the first paragraph of the general operation diagnostics say on pub. 62714540-03999
Customer: replied 1 year ago.
I get voltage at the places where it says I should. I also removed the push to start switch and checked it all for continuity.
Customer: replied 1 year ago.
I can't seem to find the 24VDC at conn P4 pin 3
Customer: replied 1 year ago.
Does that come from the motor control board?
Expert:  Kelly replied 1 year ago.
Thanks for counting on us to help with your appliance problem. My name is ***** ***** I look forward to helping you! The P4 connector is from the motor control. However, that would not make the lights fail to come on. Do you have 120 VAC between the P1-1 and the P5 connector?