How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tyler Z. Your Own Question
Tyler Z.
Tyler Z., Appliance Doc
Category: Appliance
Satisfied Customers: 73430
Experience:  9+ years being an appliance technician with factory training.
Type Your Appliance Question Here...
Tyler Z. is online now
A new question is answered every 9 seconds

When start to turn on laudry machine, the mechine run may 30

This answer was rated:

When start to turn on laudry machine, the mechine run may 30 senconds,
stop, show "F1" errer code
the lid switch was replaced, same ploblem
Laudry machine: Whirlpool M#: WTW6700TW1
Hello, and thank you for using this service. I'll be helping you with your problem today.

So F1 means that your main relay control board under the top panel in the far back right corner is shorted. There is nothing you can do but to order and replace this control board to fix the issue.

Please remember to rate my service before you leave. If you have any other questions, please ask me – I’ll be happy to respond. You can continue asking follow-up questions until you have all the information you need even after rating my service. Thank you!

Tyler Z. and 4 other Appliance Specialists are ready to help you
Customer: replied 3 years ago.

Hi, Thank you very much, for your help.

I just ask you a question for Whirlpool Washer, M#: WTW6700TW1

I forget to tell you some symtoms:

When start to turn on the washer, start to fill in water,

one of water valves to fill in water will make noise,

about 30 seconds, then washer stop, show "F1"

some time the washer will working ( very seldom )

could be water pressure senser problem ?

So not only is the water pressure sensor not the problem, the water pressure sensor is actually built into the main control board that you need to replace the F1 error anyways so it wouldn't matter if it was faulty---the board would still need to be replaced. F1 literally means that there was an EEPROM error detected in the control board so it shut down.

Related Appliance Questions