How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tyler Z. Your Own Question
Tyler Z.
Tyler Z., Appliance Doc
Category: Appliance
Satisfied Customers: 73439
Experience:  9+ years being an appliance technician with factory training.
Type Your Appliance Question Here...
Tyler Z. is online now
A new question is answered every 9 seconds

Washer goes part way through wash cycle then stops and beeps,

This answer was rated:

Washer goes part way through wash cycle then stops and beeps, we turn it off then turn it on going to the next dot and it goes through the rest of the cycle to the end.
Hello, and thank you for using this service. I'll be helping you with your problem today.

Lets see if an error code pulls up.

With the machine off, press and hold the Wash Temp Down button and then push the power button until the machine gives 2 short beeps and lights up. Now press the Spin Speed Up button three times so that the Hold and Slow LEDs are illuminated.

The eight wash progress LEDs will show the error code. Which ones are illuminated from LEFT to RIGHT? Example (1st, 5th, 8th)

If you can't pull up the error code that way, then just let the washer run until it stops and continuously beeps. WHILE IT'S BEEPING,look at the progress LEDs to see the error code. Which ones are illuminated from LEFT to RIGHT?

Customer: replied 3 years ago.

It is beeping continuous right now The 3rd wash light is lit green, the orange light is lit, the red light is lit.


OK perfect, thank you. ok so this is a pump block error. You will need to manually drain all the water in the tub then tip the machine backwards so you can access under the bottom and unplug the unit. The drain pump is located in the front right corner. It has a fan blade hanging from the bottom of it. Twist the fan blade an if it doesn't spin freely, you need to remove your drain pump and clear the blockage above it. There is a plastic tab that you can push on and then the entire pump will twist and pull off.

If the blade does spin freely, there is a "Y-connection" in the back right corner with (3) 1" hoses connected to it. Disconnect the hoses and check the "Y-connection" for any blockages. Remove any blockages if necessary.

If both things check good, then you just need to replace the drain pump itself and it costs about $100.

If you need more help, please use the reply tab to continue our conversation. If you do not require further assistance, kindly rate my service.
Tyler Z. and 2 other Appliance Specialists are ready to help you

Related Appliance Questions