My wolf oven is off and the fan noise is still on. It has been off for several hours. The fans inside are not turning.
SubZero_Wolf Expert :
The fan that you hear is the cooling fans located in the back of the unit (way back). Do you feel any air moving from the bottom of the unit?
If you hear the noise and there is no air flow then one of the cooling fans has stalled. The unit should take about 45min - 1hr to cool down normally after turning off. Also do you have the model number?
There is air flow below. The oven has been off for approx. 8 hours.
It is night time and I'm wondering if this is safe and whether I can deal with it in the morning.
Does the oven feel warm inside at all?
Then you have a failure of the sensing device that runs the cooling fan. Depending on the model wolf uses two different methods for sensing. Do you have the model number?
It is safe; the fan can run for days with no problem.
If you have a safety concern you can turn off the breaker.
model # ***** XXXXX
Can I use the oven?
Fuel ranges use the relay board to sense the temp and send power to the fans; you have a stuck relay on that board. If you turn off the power and close the door hard a few times you can unstick the relay sometimes. If that doesn't work then you will need the relay board. So long as that is the only stuck relay it will not affect the cooking performance of the machine.
How do I turn off the power?
If you let the fan run for to long (days), it will eventually fail. This would then allow the oven to over-heat, trip another sensor and shut the whole unit down.
For the power you will need to turn off at the breaker box. It would be a larger or double breaker.
It didn't work
I turned off the breaker, closed the door hard three times, turned the breaker back on and now the fan is back on again.
Then the relay is permantly stuck (happens sometimes). You will need to replace the relay board. How old is the unit?
Approx 6 years old
Shoot, the boards have a 5 year warranty. Just as a last check if you try and turn the oven on again what temp is displayed in the knob?
I will just call the appliance store to get it? Also, maybe it's only been 5 years; without a bill of sale, could I find out from Wolf?
Hate to say it but you will need that board.
I would call wolf and see if the dealer registered the unit. They also may cover it for you if it’s 5 and some months. They can also tell you the closest authorized appliance shop in your area. Those are the only places that carry wolf parts.
Can I use the oven tomorrow?
It should heat fine.