How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bryan Your Own Question
Bryan
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience:  15 yrs. experience as a certified appliance technician.
10522817
Type Your Appliance Question Here...
Bryan is online now
A new question is answered every 9 seconds

Turned on "bake" on the oven, only the broiler went on and

This answer was rated:

Turned on "bake" on the oven, only the broiler went on and wouldn't turn off, got an "F 1" message, had to unplug the stove, what is the message?
the F-1 is a problem with either the touch pad (key pad) or the ERC electronic range control. .since your broil came one and wouldn't shut off your problem is the ERC.the touch pad wouldn't do that in most cases. * Here is a simple test that you can do to determine whether the clock or the touch pad are defective when the display reads F1:

- Disconnect power to the range.
- Gain access to the back of the ERC (electronic range control, or "clock").
- Unplug the touch pad ribbon connector from the ERC. This will be a flat wire about 1 ½" to 2" wide.
- Make sure everything is clear and will not short out when power is turned back on. Replace any covers removed to gain access to the ERC.
- Turn the power back on to the range.
- Watch for the F-1 and listen for the beep.
- If you get the F-1 and beep, replace the ERC.
- If after approximately 60 Minutes you do not get the F-1 fault, replace the touch pad.

NOTE: Some models incorporate the touch pad and the clock control as one part so F1 = bad clock control.



F1Watchdog on boardReplace touch pad or clock assembly (also called the ERC)
Bryan and other Appliance Specialists are ready to help you