bosch dishwasher mod # XXXXX customer complaint that it runs fine until 1 min. left in cycle then starts over . help
Country relating to Question: United States
State (if USA): Missouri
Hello, and thank you for using this service. I'll be helping you with your problem today.Unfortunately this is a very common issue and it means that your control board inside the door has failed. There is a relay on the board that shorts out. This relay sends power to the heater, so when it fails the Dishwasher doesn't wash well and it will run forever trying to heat the water which will never happen so it just sticks on the number 1 and then keeps running. Below is a link to the control board in the upper right hand corner of the door you'll need to replace in order to fix the problem. The part costs about $220 + shipping.CLICK HERETo access the control board, just open the door and remove all the screws around the border of the door except the 2 down by the bottom of the door hinge, just loosen those two. Once you have those out, remove the 2 coming in from the sides of the control panel (left and right). The control panel will then pull off and you can access the control board inside. Remove the control panel and there are 3 tabs on the bottom of the control board you need to depress. Push on the tabs and remove the control board, then switch over connections one at a time and you should be good to go again.All I ask of you is to please rate me with one of the top 3 ratings. If there is anything else I can help you with today just let me know. You can continue asking questions for as long as you like even after you rate me. Click the continue conversation link if you would like to continue this conversation. If you are done and rate a 1 or 2 star please consider using the "continue conversation" link and telling me what more I can do or what more you would have liked that was within my power so that I possibly give you that information or help me improve my customer satisfaction rating.
7+ years being an appliance technician with factory training