Bryan - Thanks for the quick response. I don't have a high temp wash.
This is the panel
Cycles: Heavy Duty, Normal, Light/China, Quick Clean-up, Rinse Only
Options: Pro Scrub, Hi-Temp Scrub, Sani-Rinse, Heat Dry, 4-hr Delay
What should I press? Thanks - Janie
The reset didn't work.
This long number is XXXXX the Model Number:
Will this number help? janie
The Normal and Light China lights alternate very quickly.
The Cancel blinks twice and then the Start blinks once alternating. So the Cancel is quicker than the Start light.
its a keypad issue.
PROBLEM: WON'T RUN AND LED ABOVE KEY(S) IS
Short circuit(s) in keypad or in
control's input lines that read
you would need to order and replace the keypad. is your on the top of the door or front? also what color is it ?
Brian - we installed the new key pad last night. All the lights went off. However, when I push the "start/resume" button, it is solid green for a few seconds, and then it starts blinking as if I have interrupted a cycle by opening the door.
The light will blink if the door is open or if I close the door. When I press cancel, the entire panel lights are off, as they should be. I just can't get the D/W to start a wash cycle since the start button begins blinking.
I did do the reset, alternating heat dry and hi temp scrub. But even after resetting, the same thing happens.
Attachments are only available to registered users.
okay thats fine, thanks and let me know.you do not have to pay me again you already have.