How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bryan Your Own Question
Bryan
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience:  15 yrs. experience as a certified appliance technician.
10522817
Type Your Appliance Question Here...
Bryan is online now
A new question is answered every 9 seconds

DLEX2501V dryer will not start. Control panel on dryer is

Resolved Question:

DLEX2501V dryer will not start. Control panel on dryer is blank! There is power to dryer. Is there an internal fuse or circuit breaker?
Submitted: 4 years ago.
Category: Appliance
Expert:  Bryan replied 4 years ago.

Hi,Welcome to Just Answer, My name is XXXXX XXXXX forward to helping you today.

 

your getting 220 volts to the dryer ? not just 110 volts correct ?

Customer: replied 4 years ago.
120v on each leg, 240v across the two.
Expert:  Bryan replied 4 years ago.

okay thats good, you need to check for power to the power control board,part # XXXXX on this diagram. if your getting power there then the board is bad,you need to order and replace it. below is a link to the part .

 

control

Customer: replied 4 years ago.
Ok, how do you get access to the control board?

Expert:  Bryan replied 4 years ago.
its up in the control panel, take the screws out and open the panel. the board is in the control panel assembly.
Expert:  Bryan replied 4 years ago.
there are screws holding the top on the dryer in the back remove those and slide to top back to gain access to the controls. heres a link with ll the diagrams. http://www.searspartsdirect.com/partsdirect/part-model/LG-Parts/Dryer-Parts/Model-DLEX2501V/3204/0151200?pathTaken=&prst=0&shdMod=DLEX2501V
Customer: replied 4 years ago.
I see only two screws ( by the slide out water supply for steam drying ) does the decorative cover snap off? I don't
Want to damage the cover trying to remove it.
Customer: replied 4 years ago.
I read your second reply with an answer to my question. I have the circuit board in hand! I will order new board and replace, thank you for your time and expertise, DuaineAnderson .
Expert:  Bryan replied 4 years ago.
your welcome. have a great week.! thanks, Bryan
Bryan and other Appliance Specialists are ready to help you