How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Appliance Tech Larry Your Own Question
Appliance Tech Larry
Appliance Tech Larry, Home Appliance tech
Category: Appliance
Satisfied Customers: 19183
Experience:  Over 35 years of in home appliance repair and service
14308609
Type Your Appliance Question Here...
Appliance Tech Larry is online now
A new question is answered every 9 seconds

my kenmore series 90 washer wount run a spin cycle and does

This answer was rated:

my kenmore series 90 washer woun't run a spin cycle and does not drain water
Hello I'm Larry and will be helping you so please stay on line with me until we finish, If your not up to doing the repairs then please tell me now

may i have the model number and does it wash and then go dead as it goes into spin
Customer: replied 4 years ago.
It washes and then goes dead when it hit the spinc cycle marker. Checking model number
thanks ,, once i get the model i can tell you what you need to do to fix it ,,
Customer: replied 4 years ago.
mod # XXXXX 22922 100

or just 22922 100 I think.

Series CL(NNN) NNN-NNNN
thank you ,, snap off the end caps of the control panel, remove the screw under each, raise the control panel, unplug the lid switch and pop loose the two hold down clamps, slide the cabinet off the base and swap out the lid switch, its part number 3949238 which cost about $34 and you can get it at a local appliance parts dealer near you

watch this video it may help more ,, thanks

http://www.youtube.com/watch?v=MFsvLiuTniU
since i just had surgery yesterday i will be going off line in a couple minutes so if you have other questions please ask now and if not then i will be back online later ,, thanks
you have any other questions before i leave today
you still with me
Customer: replied 4 years ago.
I had to step away for a few minutes. The video was to remove a lid switch. I can test this out until tomorrow. The video was very helpful. However, if it is not the lid switch what else might it be.
i will not start guessing, this is the lid switch ,, i am 100% sure ,, thanks
Appliance Tech Larry and other Appliance Specialists are ready to help you