How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tyler Z. Your Own Question
Tyler Z.
Tyler Z., Appliance Doc
Category: Appliance
Satisfied Customers: 74271
Experience:  9+ years being an appliance technician with factory training.
13574879
Type Your Appliance Question Here...
Tyler Z. is online now
A new question is answered every 9 seconds

clean light is flashing ... start light just flashes when start

Resolved Question:

clean light is flashing ... start light just flashes when start pushed to start a cycle... will pump for 2 min when cancel pushed
Submitted: 5 years ago.
Category: Appliance
Expert:  Tyler Z. replied 5 years ago.
Hello, and thank you for using this service. I'll be helping you with your problem today.

ok you need to reset the control board. Press "high temp wash, heated dry, High temp wash, heated dry, high temp wash, heated dry, high temp wash, heated dry, high temp wash"

All the lights will go solid at which point you press cancel to reset the board.

**NOTE** if you don't have a "heated dry" button, use the "air dry" or "energy saver dry" button instead.

If the control board doesn't reset, then it will just need to be ordered and replaced because it's just shorted for one reason or another.

Tyler Z. and 3 other Appliance Specialists are ready to help you