hi there this pump has 3 clamps on it that come off to remove it
Hello. No clamps. It is on the shaft of the motor. The motor is out.
oh thats the old pump
The one in the first pic is the one. is there a way for me to send you a pic of what it looks like?
look at the water pump where the belt goes around the pulley the part of the pump on the shaft has a allen wrench screw on it holding it to the shaft
if its the one on the first pic then after those clamps it just pulls upward may be jammed after long usage
Kinda got it. ill send you some pics so we are on the same page.
Sent some pics. What you are looking at is the impellers on the inside of the pump. I broke away the plastic housing. The tray is still on there and in good shape. It looks bad in the pics, but it is ok.
ok yes now just wedge that left over piece upwards
get leverage between it and the shaft and raise upwards may be hard been there for a while
break away that tray also if you have a new one in route wont hurt any thing
So it pulls straight up, not screwed? ok ill give it a shot, thanks.
pressing accept pays me thanks