How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tyler Z. Your Own Question
Tyler Z.
Tyler Z., Appliance Doc
Category: Appliance
Satisfied Customers: 76781
Experience:  9+ years being an appliance technician with factory training.
13574879
Type Your Appliance Question Here...
Tyler Z. is online now
A new question is answered every 9 seconds

I just bought a display board and installed it. I ran the end

Resolved Question:

I just bought a display board and installed it. I ran the end of service
test & I get the error F1E3 is configuration mis-match. How do I reset the board so I can do end of service test.
The jumpers are in the same positions as the old baard.

Thank You
sam This is a Kitchenaid gas range KGSC308 LSSO
Submitted: 5 years ago.
Category: Appliance
Expert:  Tyler Z. replied 5 years ago.
Hello, and thank you for using this service. I'll be helping you with your problem today.

You need to program the board correctly first.

POWER OFF 5 SEC
POWER ON WAIT 5 SEC
CONVECTION BROIL
CLEAN
BAKED GOODS
"STOP TIME"
190
TIMER SET
START

Customer: replied 5 years ago.
Relist: Other.
I did that test and it did not work
Expert:  Tyler Z. replied 5 years ago.
if that didn't work, you need to replace the control board again because it's faulty or you ordered the wrong control board.
Tyler Z. and 3 other Appliance Specialists are ready to help you