How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bryan Your Own Question
Bryan
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience:  15 yrs. experience as a certified appliance technician.
10522817
Type Your Appliance Question Here...
Bryan is online now
A new question is answered every 9 seconds

Drain Pump vibrating not pumping

Customer Question

Drain Pump vibrating not pumping
Submitted: 5 years ago.
Category: Appliance
Expert:  Bryan replied 5 years ago.

Hi,Welcome to Just Answer, My name isXXXXX will be helping you with your appliance issue today.

 

this means the drain pump impeller is loose on the motor shaft. you will need to replace the pump. part # XXXXX on this diagram, you can order this at this blue link> http://www.searspartsdirect.com/partsdirect/part-number/Kitchena id-Parts/Dishwasher-Parts/W10158351/0022/665/Model-KUDE70FVSS0/0593/0130000?keySuffixId=NA&productTypeId=x&searchModelNumber=KUDE70FVSS0&subCompDesc=Pump,%20washarm%20and%20motor%20parts&brandDesc=KITCHENAID&modelDesc=DISHWASHER&blt=11 thanks , Bryan

Customer: replied 5 years ago.

Should there be any discharge of the sump well with this condition?

 

 

Is there any way debris could be cleared from the impeller or does the entire pump assymble have to be ordered?

Expert:  Bryan replied 5 years ago.
Well there can be some discharge of water from the sump but if it's slipping on the shaft of the motor which is probably what's going on you're not going to get full drain power, you have to water the whole pump assembly if it needs to be replaced, you can pull the machine out from under the cabinet and remove the pump and see if maybe there is something in it stopping the impeller from moving, but if that happened most likely the impeller has slipped on the motor shaft, the only fix the that is replacement, thanks, Bryan
Customer: replied 5 years ago.

So the only accessible way to pull the pump is to remove the appliance?

Expert:  Bryan replied 5 years ago.

It's a lot easier if you have the machine out, reaching the pump from the front is difficult, you may be able to do it however but getting it back in is even more difficult, I usually Pull the appliance it's just much easier to access that way, a little more work though but you are able to lay the machine on its back to work on it, which makes it a lot easier

Bryan and 2 other Appliance Specialists are ready to help you
Customer: replied 5 years ago.
Ok, thanks for the help.
Expert:  Bryan replied 5 years ago.
You're very welcome, best wishes, Bryan