Appliance Repair Questions? Ask a Technician for Answers ASAP
hello, welcome to just answer. my name is XXXXX XXXXX and i will be happy to assist you with your problem. in the crease between the top and front panel there are two clips. use a butter knife to locate these and push them straight back and lift the top. then you will find 2 screws holding the front on just down the inside, one on each side.
Where are these creases in the back of the machine
no no, between the top panel and the front panel. there is a small gap where they meet
the clips are 1-3 inches in from each side
I am upstars I will run down and try this and get back with you ASAP
Is that ok
I got the top lifted off how do I lower the front so I can reach the hoses
look in side the washer about 3 inches down on each side. there is one 5/16 screw on each side that removes the front panel.
I'll be right back
once these are removed the top will pull out and then lift off the clips at the bottom.
Ok those screws will take a bit to reach will thhe door lower after I take them out
the top of the front will tilt out and then lift off the clips
ok thank you very much
you are ver