How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bryan Your Own Question
Bryan
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience:  15 yrs. experience as a certified appliance technician.
10522817
Type Your Appliance Question Here...
Bryan is online now
A new question is answered every 9 seconds

kitchen aid elec range with error code f2 e0 need to replace

Resolved Question:

kitchen aid elec range with error code f2 e0 need to replace whatever that part is
how do i get part number and how do I replace
Submitted: 6 years ago.
Category: Appliance
Expert:  Bryan replied 6 years ago.

this is the procedure for this code,

F2

Keypad

E0

E1

STUCK KEY (shorted key)

KEYPAD DISCONNECT or KEYPAD DISCONNECTED

PROCEDURE: Before proceeding, perform steps 1 through 3 above chart to enter the

Diagnostics mode.

A. Unplug range or disconnect power.

B. Check that the keypad is firmly connected.

C. Plug in range or reconnect power.

D. Observe for longer than 1 minute.

E. If error remains then go to step F.

F. Unplug range or disconnect power.

G. Replace keypad.

H. Plug in range or reconnect power.

I. Observe for longer than 1 minute.

J. If error remains then go to step K.

K. Unplug range or disconnect power.

L. Replace display board.

M. Plug in range or reconnect power.

 

if the procedures above don't work you need to replace the keypad.

Part(NNN) NNN-NNNN width=you can order this @ http://www.repairclinic.com/SSPartDetail.aspx?s=t-kesa907pss00-%3d%3dei1061066&PartID=1061066 if needed, thanks Bryan

Customer: replied 6 years ago.

o take the entire control panel off?

 

Expert:  Bryan replied 6 years ago.
yes and then you unplug the ribbon from the keypad to test. what I usually do is get some HQ contact cleaner from Lowes or radio shack and take the ribbon out and spray the contacts on both the ribbon and board, let it sit for 5 minutes then plug the keypad back in and see if the code returns,
Bryan and 4 other Appliance Specialists are ready to help you