How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bryan Your Own Question
Bryan
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience:  15 yrs. experience as a certified appliance technician.
10522817
Type Your Appliance Question Here...
Bryan is online now
A new question is answered every 9 seconds

I have a Super Cap. 465 Mod. SF387LEG 0 1 Getting an E0 F5

Resolved Question:

I have a Super Cap. 465 Mod. SF387LEG 0 1
Getting an E0 F5 or E1 F5. Door is not locked. Where is this switch you're talking about located/
Larry
Submitted: 6 years ago.
Category: Appliance
Expert:  Bryan replied 6 years ago.

heres the procedure to check this,

F5 E0 E1-F5 Door and Latch

switches do not agree

1. If door latched:

A) Disconnect power from unit.

B) Check wires and connectors from control to door switch, then from door

switch to control. If no damage to wires and all connectors okay, proceed

to step C.

C) Replace door switch.

D) Re-apply power.

E) Press and hold any key down for 1 minute to clear -F5- failure code from

memory. -F2- will appear. Press CANCEL and observe for 1 minute to ensure

correct operation.

2. If door not latched:

A) Disconnect power from unit.

B) Check wires and connectors from control to latch switch, then from latch

switch to control. If no damage to wires and all connectors okay, proceed to

step C.

C) Repeat steps A) and B) for door switch.

3. Measure door switch (door open = switch open small low voltage terminals).

4. Measure latch switch (unlatch = switch open, CAUTION - oven light contacts

are closed).

5. If corrections are made in any step, reconnect power to control. Press and hold

any key for 1 minute to clear -F5- failure code from memory. -F2- will appear.

Press CANCEL and observe for 1 minute to verify problem has been fixed.

6. If failure remains, disconnect power, replace control.

 

this is the part you need, Part 504702part # XXXXX on this diagram, its in the back of the oven. hope this helps, thanks Bryan

 

 

link to order part.

http://www.searspartsdirect.com/partsdirect/showPart.pd?partNumber=3196113&productGroupId=0022&supplierId=664&brandId=x&documentId=O2028418&keySuffixId=NA& amp;modelNumber=x&keyId=000032&pageId=00004&productTypeId=x&searchModelNumber=SF387LEGN1&subCompDesc=Chassis&brandDesc=WHIRLPOOL&modelDesc=GAS-RANGE&blt=11

Bryan and 3 other Appliance Specialists are ready to help you