How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Tyler Z. Your Own Question
Tyler Z.
Tyler Z., Appliance Doc
Category: Appliance
Satisfied Customers: 74467
Experience:  9+ years being an appliance technician with factory training.
13574879
Type Your Appliance Question Here...
Tyler Z. is online now
A new question is answered every 9 seconds

model gltf2940eso washer. will start a cycle then stop. every

Resolved Question:

model gltf2940eso washer. will start a cycle then stop. every couple mins will try to cycle again. runs for aprox 5-10 secs. does not throw a code. any Ideas?
Submitted: 6 years ago.
Category: Appliance
Expert:  Tyler Z. replied 6 years ago.
if it only runs a few seconds and stops, that means the unit doesn't detect the belt being attached. Pull the washer forward and remove the back panel to make sure the belt is attached. If the belt is attached then replace the motor control board because it's not sensing the motor pull correctly. If the belt has fallen off, then either replace it or put the belt back on if you can.
Customer: replied 6 years ago.
only the water will run for a few secs. drum will not spin at all. belt is on and in good shape. still think it is the motor control board?
Expert:  Tyler Z. replied 6 years ago.
yes, that is going to be your problem unfortunately. You need to replace the motor control board.
Tyler Z. and other Appliance Specialists are ready to help you