Need Appliance Repair Help? Ask a Technician for Answers ASAP
that # XXXXX XXXXX not comming up, but the code means this,
If after 30 seconds not minimum 0.1l of water entered or maximum fi ll
time of 13 minutes is exceeded, the valves will be turned off and the
error code will be displayed. Press PAUSE/CANCEL twice to clear the
If there is no water in the unit:
Make sure that both valves at the water source(s) are turned on
all the way.
Check for plugged or kinked inlet hoses or plugged screens in the
Verify inlet valve operation.
If there is water in the unit:
Verify that the pressure switch hose is in good condition and
properly connected to tub and pressure switch.
Unplug washer or disconnect power.
Verify there is not a siphon problem.
Verify wire harness connections to inlet valves, pressure switch,
fl ow meter, and Central Control Unit (CCU).
Check all hoses for possible leaks.
Plug in washer or reconnect power.
Verify pressure switch operation.
Verify fl ow meter operation by blowing air through the part and
measuring the resistance.
Verify CCU operation by running a Diagnostic test or any cycle.