How JustAnswer Works:

  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.

Ask S.E.Thomas Your Own Question

S.E.Thomas
S.E.Thomas, Home Appliance Technician
Category: Appliance
Satisfied Customers: 787
Experience:  16 yrs in the field and current owner of S.E.Thomas appliance
23707800
Type Your Appliance Question Here...
S.E.Thomas is online now
A new question is answered every 9 seconds

Cabrio washer stops running in cycle @ 12 min @ spin then ul

Resolved Question:

Cabrio washer stops running in cycle @ 12 min @ spin then ul comes on and this happends even with nothing in it
Submitted: 4 years ago.
Category: Appliance
Expert:  S.E.Thomas replied 4 years ago.
this was a horrible design as far as us tech believe. the problem is one of two things. the control board, or if the tum does not move around inside the cabinet freely the the suspension balls are bad. i have people replace these once a year and they are not cheap. if your getting this code even with an empty load the board is causing this. is it every single wash or intermittent? please include model number also. its found on the rear of the cabin it
Customer: replied 4 years ago.

Model # XXXXX

this was found inside under lid above drum

 

while waiting moved drum back and forth then tried again this time on rinse/spin started @14 min sounds ok then got to 13min and runing but still running and staing @ 13 min

Expert:  S.E.Thomas replied 4 years ago.
if you use a butter knife and insert it in the crease found between the top and front about 2 inches in on each side are the top clips. push them straight back and lift the top. look around the inside of the cabinet and you will find a tech sheet. this will let you enter a diagnostic mode and test a few things so you can narrow down you problem.
Customer: replied 4 years ago.

I got it next please

 

Expert:  S.E.Thomas replied 4 years ago.
follow the instruction to put the machine in to test mode and check the rps sensor. if ok run the manual test on the motor. see if it will run through all the speeds.
Customer: replied 4 years ago.
F 51 came upa motor rotor position sensor failure or lower harness problem
Expert:  S.E.Thomas replied 4 years ago.

to access lay the washer on its back. here is the break down. the rps sensor is number 20. if the plug appears to be ok then replace. you can order it from http://www.appliancepartspros.com/ at a fair price.

 

S.E.Thomas, Home Appliance Technician
Category: Appliance
Satisfied Customers: 787
Experience: 16 yrs in the field and current owner of S.E.Thomas appliance
S.E.Thomas and 3 other Appliance Specialists are ready to help you
Customer: replied 4 years ago.

Thanks I will give it a shot

Expert:  S.E.Thomas replied 4 years ago.
your welcome. you can always come back to this question if you need.

JustAnswer in the News:

 
 
 
Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.
 
 
 

What Customers are Saying:

 
 
 
  • Thank you for the expeditious answer. It's good to know you're out there and awake in the wee hours when I finally have time to ask questions about my Jenn Air. Jean Riverhead, NY
< Last | Next >
  • Thank you for the expeditious answer. It's good to know you're out there and awake in the wee hours when I finally have time to ask questions about my Jenn Air. Jean Riverhead, NY
  • You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future. Jimmy Bagley, IA
  • Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help. Mary C. Freshfield, Liverpool, UK
  • This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!! Alex Los Angeles, CA
  • Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult. GP Hesperia, CA
  • I couldn't be more satisfied! This is the site I will always come to when I need a second opinion. Justin Kernersville, NC
  • Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around. Esther Woodstock, NY
 
 
 

Meet The Experts:

 
 
 
  • John

    Home Appliance Technician

    Satisfied Customers:

    13453
    Appliance repair business owner for over 43 years.
< Last | Next >
  • http://ww2.justanswer.com/uploads/docjohn174/2008-12-13_170143_johnask.jpg John's Avatar

    John

    Home Appliance Technician

    Satisfied Customers:

    13453
    Appliance repair business owner for over 43 years.
  • http://ww2.justanswer.com/uploads/tomgoe/2011-01-04_021913_2008-03-03_183612_phpexrmok_c2pm.jpg Tom Goellner's Avatar

    Tom Goellner

    Home Appliance Technician

    Satisfied Customers:

    1293
    32 yrs. experience servicing major appliances and HVAC equipment.
  • http://ww2.justanswer.com/uploads/MD/md2020/2012-6-6_20648_Selfpic.64x64.jpg Tyler Z.'s Avatar

    Tyler Z.

    Appliance Doc

    Satisfied Customers:

    58693
    9+ years being an appliance technician with factory training.
  • http://ww2.justanswer.com/uploads/SM/smitty1486/2011-3-1_0145_Snapshotofme1.64x64.png Kelly's Avatar

    Kelly

    Appliance Technician

    Satisfied Customers:

    8783
    Highly accurate diagnostician with over 30 years experience!
  • http://ww2.justanswer.com/uploads/AP/appliance medic/2012-6-8_212544_Image4.64x64.jpg Appliance Medic's Avatar

    Appliance Medic

    Home Appliance Technician

    Satisfied Customers:

    7932
    Factory Trained CFC Technician
  • http://ww2.justanswer.com/uploads/TE/Teamcold/2012-6-15_15028_HomeRepairsquarecopy.64x64.jpg Barry G.'s Avatar

    Barry G.

    Home Appliance Technician

    Satisfied Customers:

    6113
    27 years in home appliance repair. EPA refrigerant transition and recovery certification type I & II.
  • http://ww2.justanswer.com/uploads/TH/TheHomeSmithy/2011-8-13_11146_homesmithy.500x500.64x64.jpg The Home Smithy's Avatar

    The Home Smithy

    Home Appliance Technician

    Satisfied Customers:

    6081
    30 years repairing appliances
 
 
 

Related Appliance Questions

Chat Now With An Appliance Technician
S.E.Thomas
S.E.Thomas
owner of s.e.thomas appliance
787 Satisfied Customers
16 yrs in the field and current owner of S.E.Thomas appliance