How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bryan Your Own Question
Bryan
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience:  15 yrs. experience as a certified appliance technician.
10522817
Type Your Appliance Question Here...
Bryan is online now
A new question is answered every 9 seconds

Hi, I need to replace the handle on my front loading Whirlpool

This answer was rated:

Hi,
I need to replace the handle on my front loading Whirlpool washer model LHW0050PQ4.
I was sent a manual. However, there is no diagram of the door.

I'd love the help. Is it as simple as removing the three screws I can see?

Thank you,
Cynthia
its not really as simple as just taking the screws out, you need to watch how the old spring assembly goes in, heres the only diagram I can find, it doesn't show much though, thanks Bryan,
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience: 15 yrs. experience as a certified appliance technician.
Bryan and other Appliance Specialists are ready to help you
Customer: replied 7 years ago.
OK..so have you ever done this..cause I already have that diagram..in your experience are those door parts just layered one on another ..the picture shows one screw. Thank you
well the springs has to be set over the rod so it springs it back, its very hard to explain though, did you get all these parts with the new handle? Part(NNN) NNN-NNNN width=

good luck