How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Appliance Medic Your Own Question
Appliance Medic
Appliance Medic, Home Appliance Technician
Category: Appliance
Satisfied Customers: 10831
Experience:  Factory Trained CFC Technician
Type Your Appliance Question Here...
Appliance Medic is online now
A new question is answered every 9 seconds

My Maytag Neptune dryer wont start.. the sensor light flashes.

Resolved Question:

My Maytag Neptune dryer won't start.. the sensor light flashes. What can I do? I also want to know how to get inside the dryer to clean the area below the lint filter and and blower.
Submitted: 6 years ago.
Category: Appliance
Expert:  Appliance Medic replied 6 years ago.
Hello do you have volt meter?
Customer: replied 6 years ago.
Yes, but not in the house. It's out in the shop. what should I do when I get it and based on the results, what do I need to do then. do I get inside to the area under the lint filter and blower assembly? My older Maytag had two screws on the bottom of the front ; after removing them the front just lifted up.
Expert:  Appliance Medic replied 6 years ago.
Open the door remove the two screws on the hinge and the two on the other side then the front will pull off and you will be inside. There is a white fuse with two wires check it for continuity if so the control board is bad,
Appliance Medic and 7 other Appliance Specialists are ready to help you

Related Appliance Questions