How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bob L Your Appl Pal Your Own Question
Bob L Your  Appl Pal
Bob L Your Appl Pal, Home Appliance Tech
Category: Appliance
Satisfied Customers: 7548
Experience:  23 Years Major Appliance Repair
14958677
Type Your Appliance Question Here...
Bob L Your Appl Pal is online now
A new question is answered every 9 seconds

how to change light bulb in whirlpool microwave model #GMC305pdq07 electric

Resolved Question:

how to change light bulb in whirlpool microwave model #GMC305pdq07
electric combination built in
Submitted: 7 years ago via PartStore.
Category: Appliance
Expert:  Bob L Your Appl Pal replied 7 years ago.

Hi.....You can do .With the unit still installed remove the front control panel #10...The bulb #53 will be located behind the panel towards the back...

graphic

 

graphic

Customer: replied 7 years ago.
how do you remove the front control panel
Expert:  Bob L Your Appl Pal replied 7 years ago.

Open the door....Remove the screws along the bottom of the control panel and at the sides along the rail....

Customer: replied 7 years ago.
I taken the front panel off and that little air flow grill but still cant get to it
Expert:  Bob L Your Appl Pal replied 7 years ago.
Then what you will need to do is slide the unit out.....Remove the top cover....What i do is get a tall stool or table that is the same height as the bottom of the unit...Slide it out just enough to rest the unit on the stool ...Then remove the top cover over light....Make sure you shut power off to unit...
Customer: replied 7 years ago.
the bulb is under a metal air flow vent... I have to pull the whole unit out of the wall? and remove all the metal panels?
Expert:  Bob L Your Appl Pal replied 7 years ago.
Correct...If you cannot gain access from the front then you will need to remove the top outter cover over light....#20 (clip) is what holds the bulb in place...
Bob L Your Appl Pal and other Appliance Specialists are ready to help you