How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chas Your Own Question
Chas, Home Appliance Technician
Category: Appliance
Satisfied Customers: 16415
Experience:  Maytag, Whirlpool, GE & Kenmore Factory Trained Service Tech
Type Your Appliance Question Here...
Chas is online now
A new question is answered every 9 seconds

Hello, our dishwasher just blinked and stopped, we checked

This answer was rated:

Hello, our dishwasher just blinked and stopped, we checked the fuse,--ok
we thought we got it working but it went through one cycle, soap did not open and now we cannot get it to do anyuthing


120V 60HZ


E39927 LR11720

DId it drain the water at the end of the cycle?


Warning, If you opt me out from helping you, I will not be able to respond back,,,,Use this option only if you do not wish to communicate with me any further...

Customer: replied 7 years ago.

yes, it draine


it is one of 3 things causing this, check these items to make sure that it is not the control board itself gone bad.


  1. remove the bottom panel and make sure that you have 120 volts there, a bad electrical connection there will cause this.
  2. check the door switch to make sure that it is operating properly
  3. if the first 2 check okay then you will need to replace the control board/ timer in the console to repair this ,


Chas and 3 other Appliance Specialists are ready to help you

Related Appliance Questions