How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask north durham appliance Your Own Question
north durham appliance
north durham appliance, Home Appliance Technician
Category: Appliance
Satisfied Customers: 236
Experience:  23yrs onroad service whirlpool/maytag specialist over 25,000 calls completed factory trained
Type Your Appliance Question Here...
north durham appliance is online now
A new question is answered every 9 seconds

I loaded my dishwasher, turned the knob to start, the motor

Resolved Question:

I loaded my dishwasher, turned the knob to start, the motor runs but no water!
Submitted: 8 years ago.
Category: Appliance
Expert:  north durham appliance replied 8 years ago.
check the float switch it is usually located in the front right or left corner of the d/w if this is stuck up it will think the dishwasher is fullof water and will just run with no water it looks like a cylindrical dome shapped thing lift it up and down it should be in the down position if you listen very closely you should hear a faint click sound when moving it up and down this is the switch opening and closing if this isnt it could be a bad water valve make sure water supply to dishwasher hasnt been turned off by mistake hope this helps and is anacceptible answer please click accept if so and thank you Kevin
north durham appliance and 3 other Appliance Specialists are ready to help you

Related Appliance Questions