How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Bryan Your Own Question
Bryan, Home Appliance Technician
Category: Appliance
Satisfied Customers: 12156
Experience:  15 yrs. experience as a certified appliance technician.
Type Your Appliance Question Here...
Bryan is online now
A new question is answered every 9 seconds

Asked question earlier - couldnt get Paypal OK so

Customer Question

Asked question earlier - couldn''t get Paypal OK so here again - Broken belt on Kenmore(NNN) NNN-NNNNwasher - have all bolts out, disconnected brake yoke support - can''t separate transmission from agitator stack to replace belt - what to do? Thanks
Submitted: 8 years ago.
Category: Appliance
Expert:  Bryan replied 8 years ago.
let me check your model . I'll be back in a few minutes .Bryan
Bryan and other Appliance Specialists are ready to help you
Expert:  Bryan replied 8 years ago.
this is an old washer and takes a 95405 belt right? this is a hard belt to install . did you take the bolt out of agitator ? you must take the bolt under cap on agitator before you try to remove trans. there is a better way to do this but very hard to explain , dont think i could on internet, did belt come with instuctions/? let me know Bryan
Customer: replied 8 years ago.
No instructions with belt - belt is part # XXXXX not 95405 - I'll try to find the bolt under the cap - the schematic in my manual seems not to show one, but it may be there. How will I get back to you when I have looked at it - which may not be possible until tomorrow. Thanks for your help
Expert:  Bryan replied 8 years ago.
no problem I'll do what I can to help. thanks Bryan