Ok it seems that this is a somewhat common problem with your model washer. Unfortunatly the problem is the control board.
This is a reply from one of the techs at the manufacturers web site.
"The F01 fault code is indicating an EEPROM error or a PUMP DRIVER error. A communication error between the Central Control Unit (CCU) and the EEPROM on board the CCU occurred.
Possible causes of an EEPROM error:
- A power glitch may have caused this error. Unplug the power cord for 3 minutes then reconnect power.
Possible causes of PUMP DRIVER error:
- The pump driver fails to activate. Replace the the CCU board.
Most likely the CCU board will need to be replaced.
I recommend calling a service technician to diagnose and repair your washer."
As the part is pretty expensive you may wish to consider a new unit. For twice the cost of the control board you could get a nice basic turn the dial type washer. They are much more reliable than the digital front loaders. Repairs are also much cheaper.
If this answer satisfies your question please click on the accept button. If it does not, please tell me so. You are not expected to accept any answer that you are not happy with.
I do expect you to let me know if you are not satisfied, and what I can do to put a smile on your face.
Thank you for using Just Answer. Please tell someone about us.
Best regards; The Home Smithy
After you have accepted it is important that you leave positive feedback.