How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask DennisH Your Own Question
DennisH
DennisH, Appliance Technician
Category: Appliance
Satisfied Customers: 198
Experience:  14 years with current appliance repair company
9105687
Type Your Appliance Question Here...
DennisH is online now
A new question is answered every 9 seconds

MY Washer Wontspinout all the way whats wrong

Customer Question

No Comment Added
Submitted: 8 years ago.
Category: Appliance
Expert:  DennisH replied 8 years ago.
Answered via Just Answer Chat.
DennisH and other Appliance Specialists are ready to help you
Customer: replied 8 years ago.
need part number and insructions for belt.
Expert:  DennisH replied 8 years ago.

Hello againCustomer

I am going to have you start with removing power to Your washer.

Now remove the 2 screws at the bottom of the front panel>

graphic

Circled in red above.

The panel will then slide down and lift off.

Once the panel is off You can now see the motor in front bottom and the tub in front of You.

Look at the bottom of the motor You can see the belt around the motor pulley, it will run over to a larger pulley at the bottom of the transmission, and on the right side of the motor You will see a smaller pulley on a spring loaded arm this is the idler pulley this keeps the belt tight.

Start by rolling the belt over the edge of the the large pulley on the transmission You can help it off by rotating the pulley once You have it off this pulley it should remove fairly easy from the rest.

Installing new belt, start by seating the wedged side of belt around motor pulley and the flat back side of the belt against the idler pulley. start the belt around the transmission pulley it will only seem to make it half way but while You hold the belt with one hand rotate the pulley and guide the belt on to pulley.

Top down view the belt fits like this>

graphic

Then reverrse installation of front panel and apply power to test run.

Here is the link to the belt>

http://www.repairclinic.com/SmartSearch/smartsearch.aspx

If You need anything else please feel free to ask

Dennis

Expert:  DennisH replied 8 years ago.

Sorry the belt link was corrupted here it is again>

http://www.repairclinic.com/SmartSearch/SSPartDetail.aspx?PartID=1156860&PPStack=1

Dennis