How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Curtis B. Your Own Question
Curtis B.
Curtis B., Technician
Category: Agriculture and Farm Equipment
Satisfied Customers: 3331
Experience:  Technican turned service manager on multiple lines of equipment and rental equipment.
30244710
Type Your Agriculture and Farm Equipment Question Here...
Curtis B. is online now
A new question is answered every 9 seconds

Will ignition switch LG 6426 work in place of ignition switch

Customer Question

Will ignition switch LG 6426 work in place of ignition switch LG1496 on farmtrac 360 DTC? Jim
Submitted: 1 year ago.
Category: Agriculture and Farm Equipment
Expert:  Bradley Martin replied 1 year ago.
Do you have power to switch just nothing coming out of the switch?
Customer: replied 1 year ago.
Yes
Expert:  Bradley Martin replied 1 year ago.
The LG1496 will work but the spade terminals may not be the same as the LG6426 just be sure to look on the back of the switch and see where power is going in and going out it should be marked on both switches
Expert:  Bradley Martin replied 1 year ago.
I can not do a phone call I will be happy to help you on this conversation
Customer: replied 1 year ago.
The Lg1496 is what is on it the LG6426 has same wires in different places
Expert:  Bradley Martin replied 1 year ago.
Correct are the switches marked on the back where power and starter wires go?
Customer: replied 1 year ago.
I do not have LG6426 in front of me but while checking wiring I have 2 hots going to switch. I'm still not sure its the switch keeping it from starting. What else could it be?
Expert:  Bradley Martin replied 1 year ago.
you have 2 hot wires with switch off?
Customer: replied 1 year ago.
Yes two black and white wires
Expert:  Bradley Martin replied 1 year ago.
What happens if you take one of the wire off of the switch is it still hot?
Customer: replied 1 year ago.
Can't all the wires are soldered leading into harness with 2 plugs.
1 plug has 1 spade other plug has 2 spades.
Expert:  Bradley Martin replied 1 year ago.
Have you checked the relays behind the dash make sure it is not sticking?
Customer: replied 1 year ago.
Just tested switch with meter & seems to be working. I have 1 constant in the on position & I part-time in start position. I think the switch is ok. What to do next?
Expert:  Bradley Martin replied 1 year ago.
Check the starter signal wire from the switch. should be small wire on starter solenoid.
Customer: replied 1 year ago.
That is the part time wire I think
Expert:  Bradley Martin replied 1 year ago.
Yes should be hot while holding it in start position. make sure it is hot at the solenoid in start position.
Expert:  Bradley Martin replied 1 year ago.
Any update yet?
Expert:  Bradley Martin replied 1 year ago.
Any update today?
Expert:  Bradley Martin replied 1 year ago.
Any update today?

Related Agriculture and Farm Equipment Questions