How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Wayne Your Own Question
Wayne
Wayne, Journeyman
Category: Agriculture and Farm Equipment
Satisfied Customers: 8742
Experience:  34 + years as a mechanic
6825259
Type Your Agriculture and Farm Equipment Question Here...
Wayne is online now
A new question is answered every 9 seconds

How to get kabota v1505-e motor to start

Customer Question

how to get kabota v1505-e motor to start
Submitted: 1 year ago.
Category: Agriculture and Farm Equipment
Expert:  Wayne replied 1 year ago.

Hi I'm Wayne

I will help you with this

what is this engine in ??

did it run out of fuel ??

let me know ,Please

Customer: replied 1 year ago.
it in a case skid loader now do not know
Customer: replied 1 year ago.
my son just got it and it was suppost to run.
Expert:  Wayne replied 1 year ago.

Thank you for that

OK, you don't know if it ran out of fuel .....Correct

drop the fuel filters , install fresh clean fuel,

re-install, and loosen the injector lines and see if you get bubbles to them

when cranking over , when you see bubbles, close the lines

hold throttle to floor and crank over, hold it there until it runs smooth

I hope this helped you

Hi if this helped you

Please rate my answer 3 or more stars

If you need more info, use request button

Not Poor/Bad service

Wayne

Customer: replied 1 year ago.
already did that
Expert:  Wayne replied 1 year ago.

Thank you for that

That is a very hard engine to prime and start when run out of fuel

are you getting fuel to the injectors,

are you getting slot of exhaust smoke when cranking

let me know

Customer: replied 1 year ago.
Customer: replied 1 year ago.
can you tell me how to prime it
Expert:  Wayne replied 1 year ago.

Thank you for that

so fuel to the injectors, and lot of smoke during cranking

if you have this, that only leaves low compression

or faulty injectors, try to start it on starting fluid

see if it will go

let me know

Expert:  Wayne replied 1 year ago.

Hiu just seen your other question

If you have fuel to injectors, i is primed

at the fuel filter should be a hand primmer pump

Customer: replied 1 year ago.
we tried starting fluid and it did not work it only made it crank slower
Customer: replied 1 year ago.
we checked the gloplugs and they all work
Expert:  Wayne replied 1 year ago.

Thank you for that

If it does not start on starting fluid,

it has a compression issue

you need to do a compression test , should have between 400 to 450 PSI

with no more then 10% difference in each cylinder

I hope this helped you

Customer: replied 1 year ago.
will check compression and check back with you
Expert:  Wayne replied 1 year ago.

OK, Thank you

Please remember to rate my answer, as this is the only way I get credit for Question

The question stays open even after a good rating/Accept,

and no charge for follow up questions on same subject

Customer: replied 1 year ago.
i will pay when i get it stared or find out why it will not start
Expert:  Wayne replied 1 year ago.

Ok, Thank you

Customer: replied 1 year ago.
why did they take out the money before we got it running
Expert:  Wayne replied 1 year ago.

Hi

I have no control over that

I am a independent contractor , works from home

it is just a deposit, and refund at any time

Wayne