No Comment Added

I have a 4 cylinder 5 speed ranger. When driving it just died out. I replaced the battery starter all ignition parts including coil. When taken to a ford dealership they said it might be the computer...

Restoring 1979 F100 Lariet Ranger -302 V8 -C4 trans. Would like to replace with a C6 trans .Can it be done

Have a 97 ranger, at around 3k rpm, the charge light flickers on and the voltmeter reads low. All connections are clean/tight. Batt is full charge. It has external regulator. Is it the Reg or the...

94 Ford Ranger XLT 2.3 2WD Stick Shift - Starts fine, but when engaged to drive, car stalls and dies. The truck had blown some smoke out the exhaust, then cut out on a slip road. Not sure what the...

I just bought a 1979 F-100 Ranger XLT. I was told that it has a 302 2v carb. It does have a 2v carb but the parts I have bought are wrong. How can I tell which motor is in it? Thanks.

i had my 96 ranger transmission rebuilt the truck dont have any reverse now. Is there an easy fix for this problem or any suggestions as to what was done wrong? New torque converter was installed at...

im working on a 2002 ranger with a 2.3 i keep getting a code 1537..it says manf idle speed control..i changed the idle air sensor is that the wrong one, i cleared the code and it stays off for about...

Have a '96 Ranger and just had the timing belt and water pump replaced along iwth front crank and camshaft seals....now car overheats and does not accelerate...what is causing the...

How much oil do you put in an 84 ford ranger with a 2.8L v6?